AROW Data Sheet

AROW has been designed from the ground-up to be highly reliable, easily configurable and requiring very little maintenance, while delivering demonstrable isolation and standard Gigabit Ethernet levels of performance. Some have likened it to a uni-directional router. 

AROW Data Diode

AROW Data Diode


This is achieved because AROW includes the TCP protocol natively.

Data Diodes have traditionally used only the UDP protocol to deliver data. This is a connectionless protocol – the sending endpoint does not know about the receiving endpoint ( other than it is there) and so data lost in transmission remains lost. No attempt is made to resend or correct received data. This has the advantage that high speeds can be achieved, but at the cost of data integrity.

Where data is already in TCP form, AROW’s native support for this protocol simplifies setup and maintains data integrity. TCP is a connection-oriented protocol so embeds IP packet collision resends, packet ordering and error correction.

AROW embeds  socket servers as its Data transfer ports, consequently in single and dual channel versions, any stream of data, TCP and /or UDP  can be connected. Client socket software is used on each side of AROW, in the simplest case this need only consist of the standard Linux netcat command.

High Availability

A major innovation is the provision of automatic failover for redundant operation. This feature operates both internally and externally. 

AROW Redundant Operation


Internally, if a fault is detected, backup modules are automatically switched in and alarms raised. AROW’s hot swap modular design capability means that the unit can be repaired without interrupting its operation.

Externally, AROW detects network activity. If a network cable is detached, or a network switch becomes faulty such that errored data is received, AROW automatically switches connections, maintaining the existing network IP addresses.

In both these circumstances, TCP data is switched seamlessly, meaning that data loss is avoided.  (UDP data transfer is not supported on the HA version since there is no concept of UDP re-transmission).





 Two Channel operation – provides 2 independent paths for two data streams

Controlled Data Flow

Use of the AROWBftp open-source file transfer suite is recommended for file transfer  applications.

This includes data-flow throttling to control transfer speeds to match all levels of data processing capability.

AROW is optimised for high-speed streaming, especially where the full bandwidth of Gigabit Ethernet needs to be utilised, and data integrity can afford some losses in the event of network congestion, such as streaming video or  other application layer error corrected data.

Modular Construction

The versatile modular construction of AROW allows for single, dual and High Availability redundant diode options to be housed in a common chassis, plus the plug-in connections allow wired ethernet or optical connections to be swapped at will.

The Single Channel version is a good low-cost entry-level product, suitable for most applications.

The Dual-Channel unit can be used to load-share or provide  redundant paths for UDP data.

The High Availability unit is for systems requiring the higehts level of data throughput and integrity

Simplification of the principle module and in-field firmware programming reduces the spares count considerably, and the hot-swappable nature of the modules means diagnostic times and  down-times are absolutely minimised.

Configurable Interfaces

SFP plug-in connections are used to enable Copper RJ-45 data connections, LC optical connections or a combination of each, meaing that one side of the diode can be connected via copper and the other side by optical fiber.

AROW Data Sheet

For more detailed information Regarding the  AROW’s operations, please

ask for the  AROW manual (Chapter 2,3 and 4)